Related Manuals for King Canada 8510LPN
Summary of Contents for King Canada 8510LPN
- Page 1 2.5 GALLON WET•DRY VACUUM MODEL: 8510LPN INSTRUCTION MANUAL COPYRIGHT © 2023 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty Information
Canada service center. Contact your retailer or visit our web site at www.kingcanada.com for an updated listing of our authorized service centers. In cooperation with our authorized service center, King Canada will either repair or replace the product if any part or parts covered under this warranty which examination proves to be defective in workmanship or material during the warranty period. -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE openings and moving parts. USING THIS VACUUM. Read and understand this operator’s manual • Use extra care when cleaning on stairs. and all labels on the Wet/Dry Vacuum cleaner before operating. Safety •... - Page 4 SPECIFICATIONS POWER SUPPLY- WARNING: YOUR VACUUM MUST BE Model ................8510LPN CONNECTED TO A 120V, MINIMUM 15-AMP. BRANCH CIRCUIT. Voltage ................120V FAILURE TO CONNECT IN THIS WAY CAN RESULT IN INJURY Horsepower ............2 HP (peak) FROM SHOCK OR FIRE. Amperage ................5A Phase ..................1...
- Page 5 UNPACKING, ASSEMBLING & OPERATING YOUR VACUUM ATTENTION! The vacuum accessories are packed inside the vacuum tank. UNPACKING YOUR VACUUM Remove the entire contents of the carton, please note that the accessories are packed inside the vacuum tank. To access these accessories, undo latches (A) Fig.3, remove the tank cover/motor assembly (B) and then remove the accessories inside the tank.
-
Page 6: Operation
OPERATION 6) Plug the power cord to a power source. 7) Start the vacuum by pushing the On/Off switch to the On position as shown in Fig.8. The On position is indicated by the international symbol “I” on the switch. 8) Once the vacuuming operation is finished, push the On/Off switch to the Off position indicated by the international symbol “O”... -
Page 7: Operation And Maintenance
Reduced efficiency/increased motor speed- Inlet is block or tank is full- Unblock inlet or empty tank. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.