Iv. Assembly; Seat Installation - Pride Jazzy 600 2S Owner's Manual

Seat Installation

It may be necessary to install the seat either prior to initial
operation or after transporting your power chair. Most seats
are attached to the power base with the Universal Mount-
ing System (UMS). The UMS consists of universal parts
that may be attached to any medium-back or high-back
seat, regardless of seat width or seat depth. The two main
components are aluminum extrusions mounted to the seat
base. These extrusions attach to a pair of trapeze bars that
are mounted to the power base. See figure 11.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 11.
2. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
3. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
4. Install the controller into one of the armrests. Tighten
the setscrew. See figure 11
5. Loosen the rear shroud fasteners and remove the rear
shroud.
6. Plug the controller connector(s) into the power base.
See figure 7.
7. Reinstall the rear shroud and tighten the rear shroud
fasteners.
8. Route the controller cable so that it cannot be pinched
in the seat hinge.
9. Secure the controller cable to the armrest receiver with
one or more wire ties.
MANDATORY! Prevent controller harness damage! Avoid routing the controller harness on the outside of
the armrest pad. Route the harness under the armrest or toward the inside of the armrest pad. Use correct
tie-down points for the controller harness to prevent the harness from getting caught in the drive tires,
pinched in the seat frame, or damaged when passing through doorways.
22
I V . A S S E M B L Y
www.pridemobility.com
SETSCREW
TRAPEZE BARS
Figure 11. Universal Mounting System
REAR EXTRUSION
SEAT
LATCH
SAFETY
Jazzy 600 Series