Disassembly And Assembly - Pride PATHRIDER 130 XL Owners Manul

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into several
pieces: the seat, the front section, the rear section,
the battery shroud (if equipped), the basket, and
the batteries. See figure 20. No tools are required
to disassemble or assemble your scooter, but
keep in mind that the disassembled sections of
the scooter take up more floor space than the
assembled unit. Always disassemble or assemble
your scooter on a level, dry surface with
sufficient room for you to work and move around
your scooter–about 1.5 meters (5 feet) in all
directions. Remember
components are heavy and you may need
assistance when lifting them.
WARNING! Do not lift beyond
your physical capability. Ask for
assistance
while disassembling
assembling your scooter.
1. Remove the seat by lifting it straight up and
off of the scooter. If you encounter resistance
when removing the seat, disengage the seat
rotation lever and swivel the seat back and
forth while lifting up on the seat.
2 Gently pull the battery shroud up and off of
the scooter.
3. Disconnect the battery tie-down strap.
4. Disconnect the front-to-rear cable.
5. Unplug both battery harnesses by pulling
each harness out of its mating plug. See
figure 21.
6. Remove the batteries from the battery wells.
WARNING! Failure to unplug both
battery harnesses and the front-
to-rear cable prior to separating
the front and rear sections could
result in permanent damage to
the scooter.
36
that some scooter
when necessary
or
www.pridemobility.com
REAR SECTION FRONT SECTION
BATTERY SHROUD
Figure 20. Scooter Components
BATTERY HARNESS CONNECTIONS
FRONT-TO-REAR CABLE
BATTERY TIE-DOWN STRAP
Figure 21. Harness Connections
SEAT
BATTERIES
BASKET
Pathrider 130 XL