Pride Jazzy 600 2S Owner's Manual page 27

V . C O M F O R T
2. Loosen the foot platform securement nut one-half turn.
3. Raise or lower the foot platform to the desired height.
4. Reinstall the quick release fasteners into the foot plat-
form bracket and tighten.
5. Tighten the securement nut.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot plat-
form bracket. See figure 17.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot plat-
form bracket and tighten.
Quick Release Fasteners: The foot platform is attached
to the power base with two quick release fasteners. See
figure 17. Each quick release fastener consists of a bolt, a
lever, and a nut. See figure 18. The lever has a cam on the
end that allows it to clamp into place. The quick release
fastener has two states: clamped and unclamped. When the
lever is open, the quick release fastener is unclamped. When
the lever is closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-
quarter or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex
key. See figure 19.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew counterclockwise to raise the front
of the foot platform.
3. Turn the setscrew clockwise to lower the front of the
foot platform.
Jazzy 600 Series
A D J U S T M E N T S
UNCLAMPED
LEVER (OPEN)
Figure 18. Quick Release Fastener Operation
Figure 19. Underside of Foot Platform
www.pridemobility.com
BOLT
NUT
JAM NUT
SETSCREW
LEVER (FULLY CLOSED)
CAM
CLAMPED
27