Maintenance Instructions - Schumacher Electric XP400 Owner's Manual

8.5 Using the Air Compressor (Model XP750C)
Risk of explosion.
Read the instructions of the product being inflated before using the
compressor. Avoid over inflation, do not exceed the manufacturer's
recommended pressures. do not leave the air compressor
unattended during use.
NOTE: Before you use the compressor for the first time, you must install
the compressor hose wrap cleats. To install: Press each cleat into its
corresponding mounting holes on the back of the jump starter until it clicks
into place. Wrap the compressor hose around these cleats when it is not being
used.
1. Ensure the battery clips are securely on the storage holders.
2. Remove the air compressor hose from the storage cleats on the back of the
Instant Power™. Install adapters as necessary.
3. Attach the air compressor hose to the product or accessory to be inflated
by flipping down the lever.
4. Toggle the Compressor Switch up to the ON position and inflate the
product.
5. When the product is inflated to the proper air pressure (using the air
compressor gauge) toggle the Compressor Switch down to the OFF
position and remove the hose.
6. do not run for more than 10 minutes maximum at a time. Allow the Instant
Power™ to cool down for 10 minutes before using again.
NOTE: To prevent overheating, the compressor has built-in thermal protection
that will turn the compressor off before it overheats. If the compressor shuts
off, wait a few minutes and it will automatically restart when the compressor
cools.
NOTE: The air compressor is rated for 150 PSI.
Estimated Time for Inflating
vehicle Tires 13" to 16"
Bike Tire
Sports Balls
These times are approximate, use the air compressor gauge to ensure the
proper pressure has been reached. Do not over inflate.
9.

MAINTENANCE INSTRUCTIONS

9.1 After use and before performing maintenance, unplug and disconnect the
Instant Power™ (see sections 3 and 4).
9.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the
battery clips, cords, and the Instant Power™ case.
9.3 Ensure that all of the Instant Power™ components are in place and in good
working condition, for example, the plastic boots on the battery clips.
9.4 Servicing does not require opening the unit, as there are no user-serviceable
parts.
9.5
All other servicing should be performed by qualified service personal.
6 to 24 minutes
1 to 3 minutes
30 seconds
9
• •