Maintenance Instructions; Moving And Storage Instructions - Schumacher Electric INSTANT POWER IP-125C Owner's Manual

NOTE: Wrap cleats are provided for
convenient storage of the air compressor
hose. Wrap the hose around these cleats
when the hose is not in use.
1. Remove the air compressor hose from
the storage cleats.
2. Connect the adapter to the valve
stem by threading it onto the end. If
necessary, use one of the additional
adaptors.
3. Turn ON the compressor switch and
inflate to the desired pressure or
fullness.
4. When the desired pressure is
reached, turn the compressor power
switch OFF and remove the connector
from the valve stem.

9. MAINTENANCE INSTRUCTIONS

9.1 After use and before performing
maintenance, unplug and disconnect the
Instant Power (see sections 3 and 4).
9.2 Use a dry cloth to wipe all battery
corrosion and other dirt or oil from the
battery clips, cords, and the Instant
Power's case.

10. MOVING AND STORAGE INSTRUCTIONS

10.1 Store the Instant Power in an upright
position.
10.2 Store inside, in a cool, dry place.
10.3 Do not store the clips on the handle,
clipped together, on or around metal, or
clipped to cables. The clips on the Instant
Power are live and will produce arcing or
sparking if they come in contact with each
other. To prevent accidental arcing, always
keep the clips on the storage holders when
not using them to jump start a vehicle.
10.4 If the Instant Power is moved around the
shop or transported to another location,
take care to avoid/prevent damage to the
cords, clips and Instant Power. Failure
to do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the
Instant Power in or on any area or surface
where damage could occur if the internal
battery should unexpectedly leak acid.
5. Do not run for more than 10 minutes.
Allow the Instant Power to cool down
for 10 minutes before using again.
6. Recharge the unit before storing.
NOTE: To prevent overheating, the
compressor has built-in thermal protection
that will turn the compressor off before it
overheats. If the compressor shuts off,
wait a few minutes and it will automatically
restart when the compressor cools.
NOTE: The air compressor is rated for
150 PSI.
ESTIMATED TIME FOR INFLATING
Vehicle tires 13-16"
Bike tires
Sports balls
These times are approximate. Use the air
compressor gauge to ensure the proper
pressure has been reached. Do not overinflate.
9.3 Ensure that all of the Instant Power's
components are in place and in good
working condition, including the plastic
boots on the battery clips.
9.4 Servicing does not require opening the
unit, as there are no user-serviceable
parts. All servicing should be performed
by qualified service personnel.
10.5 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
• Charge the Instant Power's internal battery
immediately after purchase, after every use
and every 30 days.
• All batteries are affected by temperature.
The ideal storage temperature is at
70° F. The internal battery will gradually
self-discharge (lose power) over time,
especially in warm environments. Leaving
the battery in a discharged state may
result in permanent battery damage. To
ensure satisfactory performance and avoid
permanent damage, charge the internal
battery every month.
• 8 •
6-24 minutes
1-3 minutes
30 seconds