Configuring The Bridge Mode - Huawei EchoLife HG553 User Manual

Step 4 Click Next to show the Network Address Translation Settings page, just keep the
default settings. Make sure choose Data in the Service Name drop-down list box.
Step 5 Click Next to show the WAN Setup-Summary page, click Save to save the settings.
Click Back to make any modifications. Reboot the terminal so that the settings take effect.
----End

4.1.5 Configuring the Bridge Mode

To configure the Bridge mode for the WAN interface, do as follows:
Step 1 Repeat from the step1 to the step 7 of 4.1.1 "Configuring the PPPoA Mode."
On the Connection Type page, select bridge. Keep other settings by the Internet Service
Step 2
Provider.
Step 3 Click Next to show the Unselect the check box below to disable this WAN service
page, keep the default settings. Make sure choose Data in the Service Name drop-down
list box.
Click Next to show the WAN Setup-Summary page, click Save to save the settings.
Step 4
Click Back to make any modifications. Reboot the terminal so that the settings take effect.
----End
4 Configuring the WAN Interface
4-9