Configuring The Ipoa Mode - Huawei EchoLife HG553 User Manual

4 Configuring the WAN Interface
4.1.4

Configuring the IPoA Mode

To configure the IPoA mode for the WAN interface, do as follows:
Step 1 Repeat from the step1 to the step 7 of 4.1.1 "Configuring the PPPoA Mode."
Step 2 On the Connection Type page, select IP over ATM (IPoA).
Step 3 Click Next to show the WAN IP Settings page for IPoA, you can keep the default
settings or set the parameters refer to Table 4-6.
Figure 4-6 WAN IP Settings page for IPoA
Table 4-6 Parameters for the WAN IP Settings page for IPoA
Parameter
WAN IP Address
WAN Subnet Mask
Remote WAN IP
address
Primary DNS server
Secondary DNS
server
IpoA's
MTU:[296-1500]
4-8
Description
It specifies the WAN IP address of the PVC.
This parameter is provided by the Internet Service Provider.
It specifies the WAN subnet mask of the PVC.
This parameter is provided by the Internet Service Provider.
It specifies the remote WAN IP address of the PVC.
This parameter is provided by the Internet Service Provider.
It specifies the IP address of the primary DNS server used
by the PVC.
This parameter is provided by the Internet Service Provider.
It specifies the IP address of the secondary DNS server used
by the PVC.
This parameter is provided by the Internet Service Provider.
The maximum length of the transported IP package with the
selected IPoA protocol.