Table of Contents
Advertisement
4.1.3
Configuring the MER Mode
To configure the MER mode for the WAN interface, do as follows:
Repeat from the step1 to the step 7 of 4.1.1 "Configuring the PPPoA Mode."
Step 1
Step 2
On the Connection Type page, select MAC Encapsulation Routing (MER). Keep
other settings by the Internet Service Provider.
Step 3
Click Next to show the WAN IP Settings page, you can keep the default settings or set
the parameters refer to Table 4-5.
Table 4-5
Parameter
DHCP Class Identifier
WAN IP Address
WAN Subnet Mask
Primary DNS server
Secondary DNS server
IpoE's
MTU:[296-1500]
Step 4
Click Next to show the Network Address Translation Settings page, just keep the
default settings. Make sure choose Data in the Service Name drop-down list box.
Click Next to show the WAN Setup-Summary page, click Save to save the settings.
Step 5
Click Back to make any modifications. Reboot the terminal so that the settings take effect.
----End
Parameters for the WAN IP Settings page
Description
It specifies the client.
It specifies the WAN IP address of the PVC.
When the method for obtaining an IP address is set to
using a static IP address, the terminal provides this
parameter.
It specifies the WAN subnet mask of the PVC.
When the method for obtaining an IP address is set to
using a static IP address, the terminal provides this
parameter.
It specifies the IP address of the primary DNS server used
by the PVC.
When the method for obtaining an IP address is set to
using a static IP address, the terminal provides this
parameter.
It specifies the IP address of the secondary DNS server
used by the PVC.
When the method for obtaining an IP address is set to
using a static IP address, the terminal provides this
parameter.
The maximum length of the transported IP package with
the selected IPoE protocol.
4 Configuring the WAN Interface
4-7
Hide quick links:
Advertisement
Table of Contents
