Configuring The Pure Bridge Mode; Preparation - Huawei EchoLife HG520s User Manual

Home gateway
Hide thumbs Also See for EchoLife HG520s:
Table of Contents

Advertisement

Service
Mode
IPoA
Note:
ISP = Internet Service Provider
PPPoE = PPP over Ethernet
PPPoA = PPP over ATM
IPoA = Internet Protocol over ATM
Caution:
Some configurations are validated only after they are saved and the
HG520s is rebooted. Follow the prompt in the configuration page to
perform this operation.
3.3 Configuring the Bridge Mode
In the pure bridge mode, the HG520s serves as a bridge. You
need to install the PPP dial-up software to realize the dial-up access to
the Internet.
This section describes the process to configure the HG520s to
work in the pure bridge mode and the process to configure your
computer to access the network through the HG520s.

3.3.1 Preparation

Table 3-2 shows the configuration preparation.
Working Method
Take the HG520s as a router.
The HG520s uses the static public IP
address to access the Internet.
Use the IPoA encapsulation mode to
encapsulate the packets.
[a5]
13
Configuration
Refer to 3.8
"Configuring the
IPoA Mode".

Advertisement

Table of Contents
loading

Table of Contents