And Parts List - Kingsman VFI25N Installation Instructions Manual

Be sure to rinse and dry the glass well as not to
leave any marks. It will be necessary to clean the
glass up to 3 times a season depending on use of
the fireplace.
(f) Brass Trim and Surround
All Brass and Painted surfaces should only be
wiped off with a soft non abrasive damp cloth ( a
mild dish soap can be used if necessary ).
DO NOT use brass or other metal polishes,
glass cleaners or any other abrasive cleaners
as this will mark and damage brass or painted
surfaces.
(g) Venting
Venting should be inspected yearly by a qualified
service technician and replaced if necessary . Draft
action should be tested for as outlined in Section
11 to conform that conditions in the house have
not changed or that the vent has not become
blocked or damaged.
(h) Valve and Burner Replacement
For valve replacement it is recommended that the
burner assembly be removed, this is done by
removing two 1/4" hex screws on the left and right
side of the firebox and lifting the complete burner
assembly from the unit and replacing defective
component and re-installing. Check for gas leaks
after replacing burner assembly.
WARNING
Electrical Grounding Instructions
This appliance is equipped with a three prong
(grounding) plug for your protection against
shock hazard and should be plugged directly
into a properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this
The appliance area must be kept clear and free
from combustible materials, gasoline and other
flammable vapours and liquids.
Do not use this heater if any part has been
under water. Immediately call a qualified
service technician to inspect the heater and to
replace any part of the control system and
any gas control which has been under water .
15
WARNING
WARNING