2.2.8 IDE Primary Channel Slave
This parameter specifies the current configuration of the IDE device connected to the
slave port of the primary IDE channel. For information on how to configure the IDE
drives, see section 2.4.2.
2.2.9 IDE Secondary Channel Master
This parameter specifies the current configuration of the IDE device connected to the
master port of the secondary IDE channel. For information on how to configure the IDE
drives, see section 2.4.2.
2.2.10 IDE Secondary Channel Slave
This parameter specifies the current configuration of the IDE device connected to the
slave port of the secondary IDE channel. For information on how to configure the IDE
drives, see section 2.4.2.
2.2.11 Total Memory
This parameter specifies the total amount of onboard memory.
automatically detected by BIOS during the POST. If you install additional memory, the
system automatically adjusts this parameter to display the new memory size.
1st Bank/2nd Bank/3rd Bank
The 1st Bank, 2nd Bank, and 3rd Bank parameters indicate the type and size of DRAM
installed in DIMM sockets 1, 2, and 3 respectively. The None setting indicates that there
is no DRAM installed. For the location of the DIMM sockets, refer to Figure 1-1.
2.2.12 Serial Port 1
This parameter shows the serial port 1 address and IRQ setting.
AcerPower Minitower (M11E/IDCATX-2) User's Guide
The memory size is