Folding The Stroller - Joovy Scooter 0036X Instruction Manual

15 Removing/Installing the Double Sided Seat Pad
The stroller comes with a double sided seat pad. One side is a fleece material for warmth and the other is cool nylon.
• To remove the seat pad, first remove both the shoulder straps. See Section 9.
• Feed the buckle ends of the waist straps through the seat pad. See Figure 15.1.
• Separate the Velcro® strip located behind the top of the seat back. See Figure 15.2.
• Remove the double sided seat pad.
• To reattach the seat pad, first lay the pad on the seat with the desired side up. Attach the Velcro® strip behind the top of the seat back.
• Reattach the shoulder straps. See Section 9.
• Feed the buckle ends of the waist straps back through the seat pad.

16 Folding the Stroller

• Keep children away from stroller while folding.
• Close the canopy.
• Put the front seat into the most upright position.
• Stand behind stroller's handlebar.
• While pushing in the secondary lock button on the side of the right trigger, pull upward on the trigger mechanisms on both sides of the stroller
and push the handle down. See Figure 16.1. Then pull up on the fabric handle on the seat bottom. See Figure 16.2.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
• Ensure that the folding lock, on the right side of the strooler, engages over the extended rivet. See Figure 16.3.
17 Installing/Removing the Tray (OPTIONAL)
• Remove the bumper bar.
• Position the tray so that the notches on the metal tabs are on top. See Figure 17.1. Then line up the metal tabs with the slots on the stroller
and push them in until the tray clicks in to place. See Figure 17.2.
• Pull on the tray to ensure it is secure.
• To remove the tray pull out on the tabs on each side to release the tray. Then pull the tray away from the stroller. See Figure 17.3.
The tray is not a restraint device. Always secure your child with the seat belt. Never lift the stroller by the child tray. Use caution when attaching
18 Installing/Removing the Car Seat Adapter (OPTIONAL)
NOTE: The car seat adapter can ONLY be used with Graco® & Chicco® car seat models. See insert for specific models.
• Remove the bumper bar or tray.
• Recline the seat all the way down.
• Position the adapter so that the notches on the metal tabs are on top. See Figure 18.1. Then line up the metal tabs with the slots on the
stroller and push them in until the adapter clicks in to place. See Figure 18.2.
• Pull on the adapter to ensure it is secure.
• The car seat should be positioned onto the adapter so that it is facing toward the rear of the stroller. Lower the car seat into the adapter until
it clicks into place. See Figure 18.3. Pull up on car seat to ensure it is secure.
• To remove the car seat, pull the release lever (the same lever used to release the car seat from its base) and lift up.
• To remove the adapter, first remove the car seat, then pull out on the tabs on each side of the adapter to release. Then pull the adapter away
from the stroller. See Figure 18.4.
NOTE: The adapter must be removed when folding the stroller.
ALWAYS install the infant car seat so that the child is facing the rear (handle) of the stroller with the restraining straps secured.
ALWAYS position the infant car seat so that it is securely placed down inside the infant car seat adapter frame.
WARNING
!
ALWAYS keep children away from the stroller when folding.
WARNING
!
the tray when there is a child seated in the stroller.
WARNING
!