CDA SC 310 Series Manual For Installation, Use And Maintenance page 29

Operations to Be Executed for the Replacement of the Injectors of the Oven
and Grill Burners
Some models are provided with a set of injectors for the various types of gas.
If the injectors are not supplied they can be obtained from the "Service Centre".
Select the injectors to be replaced according to the "Table for the choice of the injectors".
The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body of each injector.
Oven Burner
− Lift and remove the lower panel inside the oven.
− Unscrew and remove the burner securing screw "A" (fig. 38).
− Withdraw the burner as shown in figure 31 and rest it inside the oven. Take care not to damage the
safety valve probe and the electric ignition electrode.
− Using a 7 mm box spanner, unscrew the injector (indicated by the arrow in fig. 39) and replace
it with a new one selected in accor-
dance with the "Table for the choice
of the injectors".
− Regulate the air supply to the oven
burner as indicated in the section
"Regulation of air supply to oven
and grill burners"; then replace the
burner and the other components
repeating the above steps in rever-
se order.

IMPORTANT: Check the correct
operation of the safety valve and
the ignition electrode.
Fig. 38
Fig. 39
A
29