Removing And Installing Double Doors (Some Models) - GE Profile PDCF1NBW Technical Service Manual

Removing and Installing Double Doors (Some Models)

IMPORTANT NOTES
NOTE: Door swing is not reversible.
Read the instructions all the way through
before starting.
Handle parts carefully to avoid scratching
paint.
Set screws down by their related parts to
avoid using them in the wrong places.
Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move
the cabinet.
These instructions are for removing the
doors.
Unplug the refrigerator from its electrical
outlet.
Empty all door shelves, including the dairy
compartment.
TOOLS YOU WILL NEED MAY
Adjustable Wrench
Masking Tape
Phillips Screwdriver
3/8" and 10 mm Socket
Ratchet/Driver
Thin-blade Screwdriver
– 16 –
REMOVE THE
1
REFRIGERATOR DOORS
Tape the doors shut with masking tape.
A
(for water dispenser models)
B
Start with right-hand door first: Remove
the screw securing the center hinge cover,
lift the hinge cover and place to the side
on top of the refrigerator.
Remove hinge cover
(1 Phillips screw)
(for water dispenser models)
C Remove water coupling and power
coupling.
C1
Water Coupling
Remove the metal spring
clip. Use a screwdriver to
push the red plastic locking
clip down and off.
C2
Water Coupling
Push red collar
and hold.
Pull tube.
C3
Power Coupling
Black mark
flush with
collar assembly
Pull apart power
coupling to
disconnect
(Continued next page)