Initial Operation; Computer Configuration; Asio Driver Installation - Reloop MIXAGE Interface Edition Instruction Manual

2. INITIAL OPERATION

- First make sure to turn off the device via the On/Off Button -B41- on the rear panel.
- Connect the included mains adapter to the device's DC jack -B40- and a shock-proof outlet.
- Then connect the included USB cable to the corresponding connection -B42- on the device's rear
panel and a free USB port of your computer.

3. COMPUTER CONFIGURATION

Before you can use your new device a few basic computer adjustments have to be carried out.
ATTENTION!
Please make sure that your Reloop Mixage is turned off. You will be asked during the installation
to turn the device on.
The included USB cable can already be connected (see item Initial Operation).
Please especially observe the following explanations.

3.1 ASIO DRIVER INSTALLATION

Insert the included installation CD into your computer's drive. Select the driver that best suits your
system in the „Drivers" folder and start the installation via a double click.
TIP!
Reloop regularly provides updated drivers online. For more information please read the chapter
„Updates & Support".
NOTE!
Please make sure to start the driver installation with admin rights. Otherwise the installation will
fail with an error message.
If you use Windows Vista or Windows 7 please carry out the appropriate installation setup via a click
of the right mouse button and the following selection „Run as admin".
1. First of all you will enter the language select window. Please select your preferred language.
2. Now click on the „Install the driver" button.
28