Operation And Maintenance - King Canada Power Force KPW-3000FM Instruction Manual

DETERGENT INJECTOR (LOW PRESSURE)
This high pressure washer is intended for use only with car wash or pressure washer
detergents with mild soaps. Only use detergents that are compatible with the aluminum
and brass parts of the pressure washer pump. Do not use powdered soaps, they may clog
the injection system. Follow the detergent manufacturer directions. The use of detergent
is advantageous, it ensures a quick way to soak the dirt before spraying.
To set-up the detergent injector, install it to the siphon injector fitting on the pump as
described in assembly instructions Fig.3. Then follows these instructions;
1) Pour the contents of your detergent into a container (A) Fig.11 and place it next to the
pressure washer pump.
2) When using a detergent, the stainless steel wand must be fitted with the detergent
nozzle (black). This can be done by pulling the coupler ring (B) Fig.9 backwards and
inserting the detergent nozzle, release the coupler ring to lock it in place.
3) Inspect the detergent injector filter (B) Fig.11, make sure it is not clogged. Then place
it all the way to the bottom of the container. The detergent will automatically mix with
the water.
4) If the throttle lever (A) Fig.10 is not in the fast position, the injection of the detergent
may be decreased or stop completely, in this case, move the throttle lever towards the left to increase engine speed and pressure.
Important Note: When you have finished using the detergent injector system, remove the injector filter from the detergent container and place
it in a different larger container containing only clean water and let the pressure washer run until you no longer notice detergent coming out of
the wand.
USING THE PRESSURE WASHER TO CLEAN
Most cleaning jobs can be made by using only water, but it is also advantageous to use detergent to penetrate and remove the dirt more
effectively. When using soap or a detergent, make sure the surface to clean is dry. Wetting the surface first is not recommended, it will dilute the
detergent and will reduce the cleaning effectiveness. Avoid hot surfaces or use in direct sunlight, this will minimize the chances of the detergent
damaging the painted surface. Do not let the detergent dry or it may damage the painted surface.
Allow the detergent to remain on the surface for a short time before rinsing with clean water under high pressure. Position the tip of the wand 6"
to 8" away from the surface to clean at a 45
APPLYING WAX
Right after the cleaning operation is done, you can use this pressure washer to apply wax. Place the injector filter into the wax container and
apply the wax sparingly in an even pattern over the wet surface. Once done, remove the injector filter from the container and rinse off the excess
wax. Wipe dry to reduce water spotting.
MAINTENANCE
WATER SCREEN
This pressure washer is equipped with a water inlet screen (A) Fig.12. This water screen must
be kept clean at all times or else it will restrict the water flow to the pressure washer and may
damage the pump. Remove the quick connect coupling from the water inlet, remove and clean
screen. Never operate this pressure washer without the water inlet screen in place.
OPERATION & MAINTENANCE
0 angle.
Figure 11
Figure 12