Table of Contents
Advertisement
WARNING! Before turning on your pressure washer engine, you MUST check oil level, fuel
level and air cleaner filter.
ASSEMBLY
Remove all the contents from the carton and proceed to the following assembly instructions;
Top handle
Install the top handle (A) to the frame (B) by sliding the top handle posts into the frame posts and
secure them together using 2 pan head screws, 4 washers and 2 nylon hex. nuts.
Wheels
Install the wheels to the frame by first pressing its spring loaded pin, then insert wheel shaft into frame
and align spring loaded pin with hole in frame until the pin snaps. Repeat for the other wheel.
Hose and wand supports
Assemble the hose support (C) Fig.1 to the right side of the frame using 2 pan head screws,
4 washers and 2 nylon hex. nuts. Then assemble the wand support (D) to the left side of the frame
again using 2 pan head screws, 4 washers and 2 nylon hex. nuts.
Wand and hose
Assemble the 2 piece stainless steel wand (A) Fig.2. Lower the rubber piece (B) to expose the
threaded fitting and screw the 2 pieces together, reposition the rubber piece. It is recommended to
install Teflon tape on the threads to prevent water leakage.
Next install the hose (A) Fig.3 to the wand (B) and install the other end of the hose (C) Fig.3 to the
pump outlet (D) as shown in Fig.3. It is recommended to install Teflon tape on the threads to prevent
water leakage.
Quick connect coupling and detergent injector
Install the quick connect coupling (E) Fig.3 to the water hose inlet (F). It is recommended to
install Teflon tape on the threads to prevent water leakage. Then install the detergent
injector tube (G) over the detergent siphon fitting (H).
PRE-START CHECK
OIL LEVEL
WARNING! This pressure washer has been shipped from the factory without oil or
very little oil in the crankcase. Operating the unit without the correct amount of oil can
damage the engine. Oil crankcase capacity: 0.7 litres.
Always check the oil level before starting the engine, make sure the pressure
washer is on a level surface. To check oil level;
1) Turn the oil gauge dipstick (A) Fig.4 counterclockwise, remove it and clean it with a clean cloth.
2) Fully reinsert the oil gauge dipstick and pull it out to check the oil level.
3) If the oil level is halfway up the dipstick or below, refill with SAE 10W30 oil through the dipstick hole
until the oil level reaches 3/4 up the dipstick or until it reaches the bottom lip of the dipstick hole as
shown in illustration below.
4) Reposition the oil gauge dipstick and tighten it by turning clockwise.
ASSEMBLY & PRE-START CHECK
Figure 1
Figure 2
Figure 3
Figure 4
Hide quick links:
Advertisement
Table of Contents
