Table of Contents
Advertisement
OPERATION
SPRAYING WATER & NOZZLE USAGE
This high pressure washer comes with a spray gun with stainless steel wand, its tip has a
quick connect coupler (A) Fig.11 to fit different nozzles. The spray pattern is adjusted by
installing the appropriate spray pattern nozzle to the quick connect coupler.
Five nozzles are included, 0
the quick connect coupler, pull the coupler ring (B) backwards and insert the desired
nozzle, release the coupler ring to lock it in place.
Nozzle usage:
0
0
(red)- Thin and powerful stream of water for difficult stains and debris removal.
15
0
(yellow)- Thin angled spray for focused cleaning.
25
(green)- Medium angled spray for focused cleaning.
0
40
(white)- Large fan pattern for wider cleaning applications.
0
Detergent (black)- This nozzle must be used in conjunction with a cleaning detergent at
low pressure. Only use this nozzle when using a detergent or cleaning solution.
ADJUSTING WATER PRESSURE
The water pressure is regulated by the spray gun trigger (A) Fig.12. The more you press
the trigger, the more water pressure you will have.
DETERGENT INJECTOR (LOW PRESSURE) & DETERGENT TANK
This high pressure washer is intended for use only with car wash or pressure washer
detergents with mild soaps. Only use detergents that are compatible with the aluminum
and brass parts of the pressure washer pump. Do not use powdered soaps, they may clog
the injection system. Follow the detergent manufacturer directions. The use of detergent
is advantageous, it ensures a quick way to soak the dirt before spraying.
1) Remove the detergent tank cap (A) Fig.13 and pour detergent into the detergent tank
(B).
2) When using a detergent, the stainless steel wand must be fitted with the detergent
nozzle (black). This can be done by pulling the coupler ring (B) Fig.11 backwards and
inserting the detergent nozzle, release the coupler ring to lock it in place.
3) The liquid detergent will be mixed with the cold water automatically, and discharged
through the detergent nozzle at a low pressure.
USING THE PRESSURE WASHER TO CLEAN
Most cleaning jobs can be made by using only water, but it is also advantageous to use
detergent to penetrate and remove the dirt more effectively. When using soap or a
detergent, make sure the surface to clean is dry. Wetting the surface first is not
recommended, it will dilute the detergent and will reduce the cleaning effectiveness. Avoid
hot surfaces or use in direct sunlight, this will minimize the chances of the detergent
damaging the painted surface. Do not let the detergent dry or it may damage the painted
surface.
Allow the detergent to remain on the surface for a short time before rinsing with clean
water under high pressure. Position the tip of the wand 6" to 8" away from the surface to
clean at a 45
0
angle.
MAINTENANCE
WATER INLET SCREEN
This pressure washer is equipped with a water inlet screen (A) Fig.14. This water screen must be kept clean at all times or else it will restrict the
water flow to the pressure washer and may damage the pump. Remove the water inlet screen by pulling it out from the water inlet and clean
screen. Never operate this high pressure washer without the water inlet screen in place.
OPERATION & MAINTENANCE
, 15
, 25
, 40
and a detergent nozzle. To install a nozzle to
0
0
0
0
Figure 11
Figure 12
Figure 13
Figure 14
Advertisement
Table of Contents
