Table of Contents
Advertisement
DETERGENT INJECTOR (LOW PRESSURE) & DETERGENT TANKS
This high pressure washer is intended for use only with car wash or pressure washer
detergents with mild soaps. Only use detergents that are compatible with the aluminum
and brass parts of the pressure washer pump. Do not use powdered soaps, they may clog
the injection system. Follow the detergent manufacturer directions. The use of detergent
is advantageous, it ensures a quick way to soak the dirt before spraying.
1) Remove the detergent tank caps (A) and pour two types of detergent into the separate
detergent tanks (B & C) Fig.12.
2) When using a detergent, the stainless steel wand must be fitted with the detergent
nozzle (black). This can be done by pulling the coupler ring (B) Fig.10 backwards and
inserting the detergent nozzle, release the coupler ring to lock it in place.
3) The liquid detergent will be mixed with the cold water automatically, and discharged
through the detergent nozzle at a low pressure.
4) Use the detergent dial (D) Fig.12 to control the type and amount of detergent used
using the scale as reference. Set the dial to Off position in order to shut-off the
detergent supply.
5) If the throttle lever (A) Fig.11 is not in the fast position (towards the right-low pressure),
the injection of the detergent may be decreased or stop completely, in this case, move
the throttle lever towards the left to increase engine speed and pressure.
USING THE PRESSURE WASHER TO CLEAN
Most cleaning jobs can be made by using only water, but it is also advantageous to use detergent to penetrate and remove the dirt more
effectively. When using soap or a detergent, make sure the surface to clean is dry. Wetting the surface first is not recommended, it will dilute the
detergent and will reduce the cleaning effectiveness. Avoid hot surfaces or use in direct sunlight, this will minimize the chances of the detergent
damaging the painted surface. Do not let the detergent dry or it may damage the painted surface.
Allow the detergent to remain on the surface for a short time before rinsing with clean water under high pressure. Position the tip of the wand 6"
to 8" away from the surface to clean at a 45
MAINTENANCE
WATER SCREEN
This pressure washer is equipped with a water inlet screen (A) Fig.13. This water
screen must be kept clean at all times or else it will restrict the water flow to the
pressure washer and may damage the pump. Remove the quick connect coupling
from the water inlet, remove and clean screen. Never operate this pressure washer
without the water inlet screen in place.
OPERATION & MAINTENANCE
0
angle.
Figure 12
Figure 13
Advertisement
Table of Contents
