Fuel Level; Air Cleaner Filter; Start-Up Procedures - King Canada Power Force KPW-3000FM Instruction Manual

PRE-START CHECK

FUEL LEVEL

WARNING! Make sure there is enough fuel in the fuel tank before operating.
Check the fuel level indicator window (A) Fig.5, if the red float gauge is all the way up, it is not
necessary to add fuel. If you do not see or hardly see the red float gauge, it is necessary to add
fuel.
1) If it is necessary to add fuel, first make sure the engine is OFF, then remove the fuel cap (B)
by turning it counterclockwise.
2) When refueling, make sure the fuel filter (C) Fig.5 is in place and keep in mind all safety
precautions and make sure to add enough fuel based on usage. Use clean unleaded
gasoline with a minimum of 87 octane. Do not mix oil with gasoline.
Fuel tank capacity: 2.2 Litres.

AIR CLEANER FILTER

The air cleaner filter should be checked after prolonged storage, the following steps should be
done when checking air cleaner filter;
1) Snap the top and bottom clips (A) Fig.6 backwards and remove the air cleaner cover (B).
2) Remove the air cleaner filter (C) Fig.6, wash filter in kerosene, squeeze kerosene out, soak
filter in engine oil and squeeze engine oil out.
3) Replace filter and replace the air cleaner filter cover.

START-UP PROCEDURES

Follow these instructions to safely start your high pressure washer.
1) Check engine oil level, fill to recommended level if necessary. Fig.7A.
2) Check gasoline level, fill if necessary. Fig.7B.
3) This pressure washer comes with a pump quick connect coupling. It allows you
to quickly connect or disconnect the inlet garden hose from the pump. Pulling
the mid ring will disconnect the quick connect coupling. Connect inlet garden
hose (not supplied) to the pump quick connect coupling AND TURN WATER
ON. Fig.7C. The water supply must provide a minimum of 4 GPM at 20 PSI or
the pump may be damaged.
4) Squeeze stainless steel wand trigger. Fig.7D. This will allow air to escape
from the hose in order to prime the pump. Squeeze trigger until there is a
steady flow of water.
PRE-START CHECK &
START-UP PROCEDURES
Figure 5
Figure 6
Figure 7