Polaris 2000 Universal Snow Owner's Safety And Maintenance Manual page 134

Front Rear Scissor Stop (FRSS)
To adjust the FRSS compress
the rear portion of the rear sus-
pension until the rear scissor
pivots away from the FRSS.
Turn adjuster to desired posi-
tion. The dot on the stop indi-
cates the high position. High
position is with the dot located
toward the rear of the machine.
(See illustration) Medium posi-
tion is with the dot toward the
front of the machine. CAU-
TION: Be sure both blocks are
in the same position or suspen-
sion damage may occur.
NOTE: It may be necessary to
loosen the FRSS mounting
bolts to adjust the position. Re-
tighten after adjustment.
If adjustment of the FRSS does
not provide desired ski pres-
sure, move the FRSS to the op-
tional front hole. Remove the at-
taching bolts and relocate the
FRSS block in the forwardmost
hole. Reinstall bolts and tight-
en.
After moving the FRSS to the
forwardmost hole, readjust the
FRSS until desired ski pressure
is obtained.
NOTE: The FRSS only controls
ski pressure under steady state
throttle positions or decelera-
tion. The RRSS controls ski
pressure under acceleration.
SUSPENSION
FRSS shown in high position,
as indicated by dot on stop
Rear
scissor
Forward
RRSS
Relocate FRSS to
forwardmost hole
in rail for additional
ski pressure
Forward
Block Position
Medium
Low
Low
High
129