Maintenance - DeWalt D28143 Instruction Manual

USING CUTTING WHEELS
WARNING: Do not use edge grinding/
cutting wheels for surface
applications because these wheels are not
designed for side pressures encountered
with surface grinding. Wheel breakage and
injury may result.
1. Allow tool to reach full speed before
touching tool to work surface.
2. Apply minimum pressure to work
surface, allowing tool to operate at
high speed. Cutting rate is greatest
when the tool operates at high speed.
3. Once a cut is begun and a notch is
established in the workpiece, do not change the angle of the
cut. Changing the angle will cause the wheel to bend and may
cause wheel breakage.
4. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before setting it down.

MAINTENANCE

Your D WALT power tool has been designed to operate over a
E
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and removing
accessories, before making any adjustments or removing/installing
attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.
grinding
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry
air as often as dirt is seen collecting in and around the air vents.
Wear approved eye protection and approved dust mask when
performing this procedure.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories
Since accessories, other than those offered by
WARNING:
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT, recommended accessories should be used
E
with this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
14