Table of Contents
Advertisement
Consumption of Packet Data
The Packet Data setting lets you specify when packet data (for example
Packet Data) should be used; refer to 12.6.
Native-Dialer Dependent
Whether a data channel is established via Wi-Fi or via Packet Data depends
on the Network Preferences you have chosen in the native Android applica-
tion. If a preferred Wi-Fi network is available, this network will be used for the
data channel.
Dual-Mode: SINGLE_MODE, DUAL_MODE
12.3 VoIP Settings
The IP address is the IP address or host name of your AMCC (or the first network
device in between AMC and AMCC). The default port is 5062.
12.3.1 Registrar and Port Settings
The IP address and port that have to be entered here, as well as your user credentials,
should be given to you by your system administrator.
12.3.2 Username and Password
The Username is the username that has been registered on the AMCC. Usually it is
your corporate phone number (to make it unique in the system). The Password is the
one that belongs to your username in the AMCC.
12.3.3 Protocol (Transport) and Preferred VoIP Codec
These settings should only be altered by administrators.
Select UDP, TCP or TLS (with SRTP) as the transport protocol. TCP is preferable for
longer battery life.
The preferred VoIP Codec can be set to U-law or iLBC. iLBC required less data which
makes 3G usage less expensive (depending on your data plan, refer to section 5).
Note:
The iLBC is only supported on newer devices (with ARM version 7 or later). The
iLBC codec will not be offered in the settings section if the device doesn't meet the
requirements.
amc-4_android_ug_en_2014-03
12 Administrator Settings
48
Advertisement
Table of Contents
