Lenovo ThinkPad X41 Hardware Maintenance Manual page 60

Symptom-to-FRU index
Symptom or error
0182
Bad CRC2. Enter BIOS Setup
and load Setup
defaults.—Checksum of the
CRS2 setting in the EEPROM
is not correct.
0185
Bad startup sequence settings.
Enter BIOS Setup and load
Setup defaults.
0187
EAIA data access
error—EEPROM access (read
or write) is failed.
0188
Invalid RFID Serialization
Information Area or Bad
CRC2—EEPROM checksum is
not correct (block #0,1).
EEPROM CRC2 is not correct
(block #6).
0189
Invalid RFID configuration
information area—EEPROM
checksum is not correct (block
#4,5).
0190
Critical low-battery error
0191
System Security—Invalid
Remote Change requested.
0192
System Security—IBM
Embedded Security hardware
tamper detected.
(continued)
56
MT1866/1867/1869
FRU or action, in sequence
1. Run BIOS Setup Utility.
Press F9, and Enter to
load the default setting.
Then save current setting
by pressing F10.
2. System board.
1. Run BIOS Setup Utility.
Press F9, and Enter to
load the default setting.
Then save current setting
by pressing F10.
System board.
System board.
Replace planar. Box serial
number needs to be reinstalled.
System board.
Replace planar. UUID needs to
be reinstalled.
1. Charge the battery pack.
2. Battery pack.
1. Run BIOS Setup Utility,
and then save current
setting by pressing F10.
2. System board.
System board.