Care And Long-Term Maintenance - RebelDesk 1000 Owner's Manual

CARE AND LONG-TERM MAINTENANCE

Prior to use of your Rebel Treadmill 1000, it is recommended that you check the belt for
proper lubrication, alignment and tension.
Please be aware that the first time you walk on the Rebel Treadmill 1000, the belt may sound
louder than it will after a few minutes of use.
WARNING! Before cleaning or maintenance of the Rebel Treadmill 100, make sure that the
machine is turned OFF and unplugged.
BELT AND DECK LUBRICATION
Routine lubrication of the treadmill deck is recommended to ensure the maximum life of your
machine.
The deck was lubricated by the manufacturer, but the lubricant may have dried between the
time of manufacture and the time of purchase. It is recommended that you lift the treadmill
belt and inspect for sufficient lubrication prior to the first use.
WARNING! STOP the machine, unplug the machine, and remove the safety key before
checking for lubrication or lubricating the deck.
Going forward, it is recommended that you lubricate the treadmill deck a minimum of once
EVERY THREE MONTHS, even if the machine is not in use. If the machine is used heavily,
then you should lubricate it more frequently.
To lubricate the treadmill deck, follow these steps:
A. Locate the silicone bottle in the hardware kit package. Use the silicone spray that is
supplied by Rebel Desk. You should use only 100% silicone spray and not an aerosol spray.
B. Find the straw and place it onto the silicone bottle, as the drawing shows.
C. Spray the silicone evenly on the treadmill deck, as the drawing shows.
Do not put too much silicone on the deck. Excessive lubricant may cause slippage of the belt
on the rollers. Wipe any excessive silicone off of the machine once you are finished.
HOW TO SPRAY SILICONE ON DECK
A
Silicone bottle
B
Straw
Put on straw
8
C
SPRAY AREA