Related Manuals for RebelDesk 1000
Summary of Contents for RebelDesk 1000
- Page 1 REBEL TREADMILL 1000 OWNERS MANUAL It is a good idea to retain this Owners Manual for future reference. But if you are not very good at retaining things, you can find a copy at www.rebeldesk.com...
- Page 2 Before you begin using your Rebel Treadmill 1000, please read the entire Owners Manual. It has a lot of valuable information to help you assemble, maintain, and get the most out of your Rebel Treadmill 1000.
-
Page 3: Table Of Contents
Table of Contents UNPACKING REVIEW OF THE WARNINGS IMPORTANT SAFETY INSTRUCTIONS POSITIONING THE REBEL TREADMILL 1000 ATTACHING THE CONTROL PANEL PLUGGING IN THE REBEL TREADMILL 1000 CARE AND LONG-TERM MAINTENANCE BELT ADJUSTMENT 9~10 CONTROL PANEL OPERATION EASING INTO YOUR REBEL TREADMILL 1000... -
Page 4: Unpacking
Failure to do so could result in injury. Read and understand all of the instructions before assembly or use. The following items should be in your Rebel Treadmill 1000 package. If any of the following items are missing, contact Rebel Desk prior to assembly or use. -
Page 5: Review Of The Warnings
REVIEW OF THE WARNINGS Review all of the warnings and labels on the Rebel Treadmill 1000. Refer to the illustration below for the location of the warnings and labels. 110V~... -
Page 6: Important Safety Instructions
• Clip the SAFETY KEY onto your clothing and carefully test it. • Set up the machine on a solid, level surface. DO NOT operate the Rebel Treadmill 1000 uader any of the following conditions: • With a damaged cord or plug. - Page 7 • Disconnect from all power sources before servicing the Rebel Treadmill 1000 by first turning all controls to the OFF position and then removing the plug from the outlet. • Keep the Rebel Treadmill 1000 unplugged when not in use to reduce the risk of electric shock.
-
Page 8: Positioning The Rebel Treadmill 1000
An example is illustrated below. Make sure that the Rebel Treadmill 1000 is on a level surface. You can level the machine by adjusting the feet on the bottom of it. To adjust the feet either higher or lower, raise the machine... -
Page 9: Attaching The Control Panel
ATTACHING THE CONTROL PANEL Locate the back of the control panel. Plug the wire terminal into the output of the control panel. Place the safety key on the circular opening on the control panel. Place the control panel on top of the desk. -
Page 10: Plugging In The Rebel Treadmill 1000
Check with a qualified electrician or service provider if you are in doubt as to whether the Rebel Treadmill 1000 is properly connected. Once the Rebel Treadmill 1000 is properly plugged in, you may turn the switch at the front of the machine to the ON position. -
Page 11: Care And Long-Term Maintenance
Prior to use of your Rebel Treadmill 1000, it is recommended that you check the belt for proper lubrication, alignment and tension. Please be aware that the first time you walk on the Rebel Treadmill 1000, the belt may sound louder than it will after a few minutes of use. -
Page 12: Belt Adjustment
BELT ADJUSTMENT You may need to adjust the treadmill belt by increasing or decreasing the belt tension or centering the belt. The treadmill belt can be adjusted by turning the adjustment bolts. Turning the adjustment bolts to the right tightens the belt and turning it to the left loosens the bolt. Centering the treadmill belt The belt is adjusted at the factory. - Page 13 CLEANING It is recommended that you wipe down your Rebel Treadmill 1000 at least once per week. To clean the machine, use a soft cloth, slightly dampened with water. Be careful not get excessive moisture on the display panel as this might cause an electrical hazard or electronics to fail.
-
Page 14: Control Panel Operation
CONTROL PANEL OPERATION The overlay of the control panel Instructions for Operating the Control Panel START Starts the treadmill belt moving. The machine automatically will go to 0.5 mph. STOP Stops the treadmill belt from moving. VIEW Allows you to change the display to show Time, Speed, or Distance. -
Page 15: Easing Into Your Rebel Treadmill 1000
EASING INTO YOUR REBEL TREADMILL 1000 Okay, now your Rebel Treadmill 1000 is plugged in and ready to be used safely. We know that you are excited to get walking. To maximize your experience, it is best to ease into a walking routine. -
Page 16: Trouble Shooting Guide
TROUBLE SHOOTING GUIDE Your Rebel Treadmill 1000 was tested extensively to ensure proper and safe functioning. In the event that you experience a problem with the machine, refer to these possible solutions. If the display on the control panel will not illuminate: •... -
Page 17: Warranty
WARRANTY Rebel Desk warrants that the Rebel Treadmill 1000 is free from defects and ready for normal operation and use as described in this Owners Manual. Rebel Desk provides the following warranties: • 1 year parts, labor, and electronics • 2 years for the motor •... -
Page 18: Parts List
PARTS LIST Parts list Bolts DESCRIPTION ITEM ITEM DESCRIPTION Main frame ST86-AB1 Nylon M8 Rubber cushion ST08-B21 Mobile wheel Rubber cushion B21B ST06-B21 Washer M8 Running belt ST28-B22 Motor Side rein ST28-B23 Nut M4 ST70-B24 Upper motor cover Upper motor cover Roller cover,left -B26 Self tapping screw 4X15mm... -
Page 19: Exploded Drawing
EXPLODED DRAWING...