Summer / Heating Limit - Honeywell Heating Controller SDC Operating Instructions Manual

Operation
4.2.3.3.3
Setting
4.2.3.4
54
Individualised operating mode for each heating circuit
Each heating circuit can be assigned an individualised operating
mode.
► Press
► Select desired heating circuit (HC, MC-1 or MC-2) by turning
the input button
C
► Confirm selected circuit by pressing the input button
► Select flashing operating mode by turning the input button
► Confirm set operating mode by pressing the
input button
► With short-term operating modes (ABSENT, PARTY), set
desired target value by turning the input button
set value by pressing the input button
Alternative: Automatic acceptance of the value after the set
information time (see 4.1.2.7 "System information" button, pg. 26).
Pos: 50 /156-Honeywell/Bedienung/Somm er_Heizgrenze @ 1\m od_1207647058244_6.doc @ 9900

Summer / Heating limit

This parameter specifies the end of heating operation depending
on the outside temperature based on the following criteria:
Quick increase in outside temperature
If the averaged outside temperature is below the set value and
the current outside temperature is 2 K above the set value,
heating operation is interrupted.
Slow increase in outside temperature
Deactivation is also initiated when the averaged and current
outside temperature exceeds the set value.
button.
î .
î
.
SDC / DHC
î .
button or the
î and confirm
î .
EN2H-0220GE51 R1111
î .