Humidity Control - Kenmore TSTAT0713K Owner's Manual

Basic Operation
Press the Humidity button
HUMIDITY
to enter Setup screens.
Pages 18-20, 24
Current Room Humidity
Adjust the desired
humidification setpoint
(0%-60%) Page 24
Step 1 appears only if step 3 is set to "ON"
Current Room Humidity
Adjust the desired dehumidify
setpoint. There is a forced
5% differential between the
humidify and the dehumidify
setpoints.
(25%-99%)
Page 24
Step 2 appears only if step 4 is set to "ON"
Current Room Humidity
ON
Select On to energize
the humidifier system when
humidity drops below the
desired level. Select Off
if no humidification is
desired.
OFF
Current Room Humidity
ON
Select On to energize
the dehumidification
system when humidity
rises above the desired
level. Select Off if no
OFF
dehumidification is desired.
NOTE: You cannot set the dehumidify setpoint any lower than the humidify
setpoint; a 5% differential is forced between the humidify and dehumidify
setpoints. When both humidify (step #3) and dehumidify (step #4) are set to
ON, the dehumidify setpoint will automatically be raised to 5% above the humidify
setpoint, when required.
NOTE: Due to variations in environmental conditions, it is not always possible
to achieve the desired humidification or dehumidification setpoint.

Humidity Control

NOTE: Each step # is located at
45
25
ON
humidify
%
45
60
ON
Dehumidify
%
45
OFF
humidify
45
OFF
Dehumidify
Press the HUMIDITY button to leave the
Humidity Control screens (if no buttons are
pressed, the display will leave the Humidity
Control screens after 60 seconds).
Page 8
the top right corner of the
display for easy reference.
I
Press
MODE
2
Press
MODE
3
Press
MODE
4
Press
HUMIDITY