Club Car DS Golf Car Owner's Manual page 53

NOTE: An oil drip guard (3) can be used to prevent excess oil from dripping into the engine base plate. Use an empty
quart (one liter) container and cut the bottom off at an angle, then slide the open area of the container up and
under the oil filter prior to removing. Position the port of the plastic container so oil will be directed into the oil
pan. Or, make a drip guard by folding a piece of cardboard, thin metal, or plastic under the oil filter forming a
channel to direct the filter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
26
Figure 34 Remove Engine Oil Filter
10. Use a clean rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
11. Coat new oil filter gasket with clean engine oil and install the oil filter onto the engine oil filter port (Figure 35).
NOTE: Use only Club Car oil filters (CC P/N 103887901) designed for this engine.
12. Hand tighten 2/3 to 3/4 turn after filter gasket contacts mounting surface.
13. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil into the
dipstick port. With filter change, the engine requires 38 ounces (1.12 liters) of oil per change. Refer to oil viscosity
guidelines for selection of oil grade (Figure 36). Replace the dipstick.
27
Figure 35 Coat Oil Filter Rubber Seal
SAE 10W-30/ SAE 10W-40
SAE 5 W-30
213
Figure 36 Oil Viscosity Chart
DS Golf Car Owner's Manual
Engine Oil – Gasoline Vehicles
SAE 30
Page 51