Club Car DS Golf Car Owner's Manual page 43

1. Keep the batteries clean and free of corrosion. Wash tops and terminals of batteries with a solution of baking
soda and water (1 cup (237 mL) baking soda per gallon (3.8 L) of water). Rinse solution off of the batteries. Do
not allow this solution to enter the battery. Be sure terminals are tight. Let the terminals dry and then coat with
Battery Terminal Protector Spray (CC P/N 1014305). See following NOTE.
NOTE: Dispose of waste water properly.
2. Check the electrolyte level weekly (Figure 22). Add water only after charging unless the electrolyte level is below
the top of the plates. In this case, add just enough water to cover the plates, charge, and then check the level
again. Never charge batteries if plates are exposed above electrolyte level. For best battery life, add only
distilled water. See following CAUTION and NOTE.
CAUTION
• Do not overfill the batteries.
NOTE: A battery watering gun or bottle is available at many auto parts dealers.
3. The battery hold-downs should be tight enough so that the batteries do not move while the vehicle is in motion,
but not so tight as to crack or buckle the battery case. For 12-volt batteries, tighten hold-down retaining nuts to 72
in-lb (8.1 N·m). For 8-volt batteries, tighten retaining nuts on the two inner hold-downs to 115 in-lb (13 N·m), and
tighten the retaining nuts on the two outer hold-downs to 55 in-lb (6.2 N·m). The terminal connections should be
clean and tight, and any worn insulation or frayed wires should be replaced. Tighten battery terminals to proper
torque. See Connecting the Batteries – Electric Vehicles on page 12. See following WARNING.
WARNING
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to
do so may cause them to overheat during operation and could result in fire, property damage, or
personal injury.
4. After use, charge the batteries. The batteries should never be left discharged any longer than absolutely
necessary (do not leave discharged overnight).
1
1. Level Indicator 2. Cap 3. Plates
Maintain electrolyte level from at least ½ inch (13 mm) above
plates to ¼ inch (6 mm) below level indicator.
17
Figure 22 Battery Electrolyte Level
2
3
Batteries – Electric Vehicles
DS Golf Car Owner's Manual Page 41