Zboost Base Unit Light Indicators; Technical Specifi Cations - zBoost Trio Xtreme Reach ZB585X Manual

zBoost TRIO Xtreme REACH ZB585X Manual
®

zBoost Base Unit Light Indicators

During Initial Power Up
Light Mode Status Solution
Cycle RED, System is N/A
GREEN, powering up.
ORANGE Please allow up
to 30 seconds.
Flashing BASE UNIT will 1. Unplug the BASE UNIT power supply.
GREEN fl ash GREEN
2. Relocate the EXTERNAL ANTENNA to pick up the
once for every
strongest signal from your wireless carrier.
2 dB less than
optimal system
3. Move the EXTERNAL ANTENNA as far away from the
gain. Three
INDOOR ANTENNA as possible, with at least 15 ft. of
fl ashes or less
vertical separation (height difference).
indicates the
system will still
4. Plug the BASE UNIT power supply back in.
operate properly.
5. Wait 30 secs. for the BASE UNIT to power cycle on.
After Initial Power Up
Light Mode Status Solution
SOLID zBoost is ready. N/A
GREEN
Flashing zBoost is in use. N/A
GREEN
SOLID EXTERNAL 1. Unplug the BASE UNIT power supply.
ORANGE ANTENNA
2. Move the EXTERNAL ANTENNA as far away from the
and INDOOR
INDOOR ANTENNA as possible, with at least 15 ft. of
ANTENNA
vertical separation (height difference).
are too close
together.
3. Plug the BASE UNIT power supply back in.
4. Wait 30 secs. for the BASE UNIT to power cycle on.
SOLID RED Signal from the 1. Unplug the BASE UNIT power supply.
carrier's cell
2. Relocate the EXTERNAL ANTENNA to another spot.
tower is too
strong for the
3. If you have a directional antenna re-aim it to reduce
BASE UNIT to
carrier signal strength.
operate properly.
4. Plug the BASE UNIT power supply back in.
5. Wait 30 secs. for the BASE UNIT to power cycle on.
Flashing Excessive ^ Refer to Solution #2
RED electronic noise
in the system –
the BASE UNIT
will not operate.
10
zBoost TRIO Xtreme REACH ZB585X Manual
®
Technical Specifi cations
Product Specifi cations for zBoost TRIO Xtreme REACH ZB585X-V
Verizon LTE
Uplink: 776—787 MHz
Frequency
Downlink: 746—757 MHz
Band supported 13
System gain 68 dB
Output power 3 dBm
Networks LTE (Verizon)
General Specifi cations
Power Consumption
Wall Supply Input ; Voltage
Input and Output Impedance
System Certifi cations
Base Unit Size and Weight
Operating Conditions
Coverage (open areas)
Product Specifi cations for zBoost TRIO Xtreme REACH ZB585X-A
AT&T LTE
Uplink: 704—716 MHz
Frequency
Downlink: 734—746 MHz
Band supported 17
System gain 68 dB
Output power 3 dBm
Networks LTE (AT&T)
General Specifi cations
Power Consumption
Wall Supply Input ; Voltage
Input and Output Impedance
System Certifi cations
Base Unit Size and Weight
Operating Conditions
Coverage (open areas)
The Manufacturer's rated output power of this equipment is for single carrier operation. For
situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB,
especially where the output signal is re-radiated and can cause interference to adjacent band users.
This power reduction is to be by means of input power or gain reduction and not by an attenuator at
the output of the device.
This product is covered by patent US 7,706,744. Other U.S. and foreign patents pending.
PCS CEL
Uplink: 1850 1910 MHz Uplink: 824
— —
Downlink: 1930 1990 MHz Downlink: 869
—
A, D, B, E, F, C A, B, A', B'
78 dB 69 dB
4 dBm 3 dBm
CDMA, GSM, GPRS, EDGE, EVDO, 1xRTT, UMTS,
HSPA, 3G
3W standby; 7W max signal - 2.5A Max
100-240VAC, 50-60 Hz; 5.0VDC
TNC Connector: 50 Ohm; F Connector: 75 Ohm
FCC Parts 15 & 20, Industry Canada
5" x 7" x 1.25" – 9 oz.
Indoor Use Only (40° - 105° F)
Up to 5,500 sq. ft.
PCS CEL
Uplink: 1850 1910 MHz Uplink: 824
— —
Downlink: 1930 1990 MHz Downlink: 869
—
A, D, B, E, F, C A, B, A', B'
78 dB 69 dB
4 dBm 3 dBm
CDMA, GSM, GPRS, EDGE, EVDO, 1xRTT, UMTS,
HSPA, 3G
3W standby; 7W max signal - 2.5A Max
100-240VAC, 50-60 Hz; 5.0VDC
TNC Connector: 50 Ohm; F Connector: 75 Ohm
FCC Parts 15 & 20, Industry Canada
5" x 7" x 1.25" – 9 oz.
Indoor Use Only (40° - 105° F)
Up to 5,500 sq. ft.
11
849 MHz
894 MHz
—
849 MHz
894 MHz
—