Table of Contents
Advertisement
Key Functions
NOTE:
22
Site Select Keys
-
Used for camera and monitor selection in Digiplex operation mode, or camera and
0
9
multiplexer selection in multiplexer operation. Also used for preset position
selection when applicable.
Refreshes alphanumeric display on the selected monitor. Also used to clear
clear
infinite alarms using numerical keys.
Used in combination with
set
to engage the preset tour mode.
auto
Pan/Tilt/Zoom Control Keys
zoom
,
zoom
Used to control the zoom function of the selected receiver site's motorized lens.
out
in
,
Used to control the focus function of the selected receiver site's motorized lens.
focus
focus
near
far
Also used to disengage the autofocus feature on the CyberDome.
,
Used to control the iris function of the selected receiver site's motorized lens. Also
iris
iris
open
close
used to enable Backlight Compensation option.
Used to move the selected receiver site's camera up, down, left, or right in P/T
operation. Used to select views for multiplexer operation.
Used to toggle between fast, medium and slow speed control for variable speed
P/T/Z camera assemblies.
Places the selected receiver site's pan/tilt unit in the auto pan mode (camera pans
auto
left and right automatically). When held down for one second, engages autofocus
feature on CyberDomes. Also used in combination with
tour mode.
Video Switcher Control Keys
Used in combination with the number keys (0-9) to select an active monitor.
mon
Used to select sequence tour on active monitor.
seq
Toggles the active monitor between the alarm on and alarm off modes.
alarm
Multiplexer Function Keys
The following keys may function differently, or not at all, on some models of multiplexers.
Toggles the keypad between Digiplex, multiplexer, and VCR control modes.
mode
Selects automatic switching of videos in lower right window of current view; also
run
used in setup of motion detection areas.
sel
Used to select an active multiplexer or VCR.
zoom
Toggles between a full screen view and a 2x view of the selected video, if available
on the specific multiplexer.
KTD-400 Controller Keypad Installation and Operation Manual
through
to find preset positions. Also used with
0
9
to initiate the preset
set
1034790D / January 2001
Advertisement
Table of Contents
