System Component Programming - KALATEL KTD-400 Installation And Operation Manual

KTD-400 Controller Keypad Installation and Operation Manual
System
Component
Programming
1034790D / January 2001
Once the KTD-400 keypad programming has been completed, it can be used to program
Digiplex system components. To program system components, begin at the normal
operating display and proceed as follows:
Figure 21: Normal Operating Display
Step 1) Press and hold the
Figure 22: Code Entry Display
Step 2) Enter the access code
to the next menu.
Figure 23: First Menu Display
From this menu it is possible to perform video switcher programming, P/T/Z receiver
programming, alarm interface programming, and CyberDome programming by pressing the
corresponding number on the keypad.
P/T/Z receiver programming instructions can be found on the following pages. For detailed
programming instructions on the CyberDomes, alarm interfaces, and video switchers,
please refer to the product programming instructions.
CAMERA 000
MONITOR 01
key until the following display appears:
set
CAMERA 000
MONITOR 01
, , , . The display will automatically advance
9 5 1 seq
1=SWTCH 2=PTZ 3=ALRM
4=CYBER SEQ=EXIT
(CODE)
(----)
15