KALATEL KTD-400 Installation And Operation Manual page 14

VCR Enabled
Maximum Presets
Monitor Offset
NOTE:
14
Figure 18: VCR Enabled Display
Step 10) This menu determines which VCRs can be enabled (accessed) from the keypad.
This menu will only come up if at least one VCR is in the system (see Step 4). To
enable a VCR, press
will advance to the next VCR, or the
0
VCR's. Press
Figure 19: Maximum Preset Display
Step 11) This menu determines the maximum number of programmable presets that can
be accessed from the keypad. The range is from 00 (none) to 63. Press
advance to the next menu.
Figure 20: Monitor Offset Display
Step 12) The default program for the keypad dictates that the selected monitor number will
correspond to the number of the matrix switcher output to which it is connected.
For example, if Monitor 12 appears in the keypad's display window and a camera
selection is made, the monitor that is connected to output 12 of the matrix switcher
will switch to that camera.
In some applications, a user may prefer to have the monitors numbered simply as
"1", "2", "3", etc., instead of using the matrix switcher output number. To allow for
the difference in numbers, simply subtract the desired monitor number from the
matrix switcher output number, and enter the result as the monitor offset.
Example: Suppose a keypad has a monitor that is connected to matrix switcher
output #12. To enable the monitor to be addressed as Monitor #1, subtract 1 from
12 and enter the result (11) as the monitor offset.
(Matrix Switcher Number) - (Monitor Number) = (Offset)
In this particular example, if more than one monitor were to be controlled from the
keypad, additional monitors would be connected to matrix switcher outputs 13, 14,
15, etc. and would be controlled as Monitor 2, Monitor 3, Monitor 4, etc.
The keypad will deny any monitor offset number that conflicts with "Largest Monitor" and
"Monitor Access" programming choices that were made earlier in this section (Refer to
Step 4 and Step 6).
After the entry, the display will return to the Normal Operating Display.
KTD-400 Controller Keypad Installation and Operation Manual
VCR 01 ACC=YES
0=NO 1=YES
. This must be done for each VCR in the system. Pressing
1
to advance to the next menu (see previous note).
seq
MAX PRESET: 09
(00 FOR NONE)SEQ=NXT
MONITOR OFFSET
NUMBER?
(12) - (1) = (11)
SEQ=NEXT
keys can be used to move between
SEQ=NEXT
1034790D / January 2001
to
seq