Zanussi ZWG 685 User Manual page 20

After removing all the
packaging, carefully lay
machine on it's back to re-
move the polystyrene base
from the bottom.
Unscrew the three bolts.
Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
rugs etc. Check that the machine does not touch the wall
or other kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be tight to adjust
as they incorporate a self locking nut, but the machine
MUST be level and stable.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation. Never place card-
20
Remove the power supply
cable and the hoses from
the hose holders on the
rear of the appliance.
Slide out the relevant plas-
tic spacers.
board, wood or similar materials under the machine to
compensate for any unevenness in the floor.
Water inlet
Warning! This appliance must be connected to a
cold water supply
Caution! Before connecting up the appliance to new
pipework or to pipework that has not been used for
some time, run off a reasonable amount of water to flush
out any debris that may have collected
Caution! Do not use the hose from your previous
appliance to connect to water supply.
35°
The other end of the inlet hose which connects to the
appliance can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the hose
to the left or right depending on the position of your
water tap. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
If necessary, check the
setting with a spirit level.
Connect the hose to a tap
with a 3/4" thread. Always
use the hose supplied with
the appliance.
45°