Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.
Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
This appliance is designed for domestic use. ● It must not be used for purposes other than those for which it was designed. Only wash fabrics which are designed to be ● machine washed. Follow the instructions on each garment label. Do not overload the appliance.
Control panel and functions Programme selector dial and On/Off switch Spin reduction button Options button Extra Rinse button Start/Pause button Programme progress display Delay Start button The programme selector dial allows to select a ● programme and/or to switch the machine on/off. It can be turned either clockwise or anticlockwise.
Programme table Programme/ Type of laundry Temperature White cotton (heavy soiled cotton items): e.g. Cottons sheets, tablecloths, 95° household linen, towels. White and fast coloured cotton Cottons (normally soiled cotton 60° Eco items): sheets, household linen, underwear, Coloured cotton lightly Cottons soiled, shirts, blouses, 60°...
Programme table Programme/ Type of laundry Temperature Programme for wool Wool «Pure new wool, non- 40° shrink, machine washable» label. Handwash Special programme for 30° - Cold hand washing fabrics Mini 30’ Short cycle for lightly soiled fabrics 30° Silk Silk items to be gentle washed and spun.
Programme information Washing programme for machine washable wool as well as for hand Wool and washable woollens and delicate fabrics with the «hand washing» Handwash care symbol Selecting this programme the laundry is gently washed and spun to Easy Iron avoid any creasing.
Washing hints Sorting the laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. Temperatures for normally soiled white cottons 90° or 95° and linen (e.g. tea cloths, towels, tablecloths, sheets...) for normally soiled, colour fast garments (e.g.
Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold.
Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called «degrees» of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority.
Operating sequence 1. Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. 2. Measure out the detergent and the fabric softener Pull out the dispenser drawer until it stops.
Operating sequence rate. On Cotton, Synthetic, Delicates, Silk, Sport Shoes 40°, and Sport 40° programmes the rinses will be performed with more water. When the programme has finished the «Door» and «End» pilot lights are alight, the Start/Pause and «Wash» lights are off and the door is blocked to indicate that the water must be emptied out.
Operating sequence The «Wash» and «Door» lights are alight to indicate that the appliance starts operating and the door is locked. To interrupt a programme which is running, depress the Start/Pause button: the corresponding green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press the Start/Pause button again.
Altering an option or a running programme It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the Start/Pause button. Changing a running programme is possible only by resetting it.
Care and cleaning IMPORTANT! You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine.
Remove any objects from the pump impeller ● by rotating it. Put the cap back on the emergency emptying ● hose and place the latter back in its seat. Screw the pump cover ● fully in. Close the pump door. ●...
Something not working IMPORTANT! Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the machine is not working.
Malfunction The machine fills then empties immediately: The machine does not empty and/or does not spin: There is water on the floor: Unsatisfactory washing results: Possible Cause / Solution The end of the drain hose is too low. • Refer to relevant paragraph in «water drainage» section.
Malfunction The door will not open: The machine vibrates or is noisy: Spinning starts late or the machine does not spin: The machine makes an unusual noise No water is visible in the drum If you are unable to identify or solve the problem, contact our service centre.
Technical data Dimensions Electrical connection Voltage - Overall power - Fuse Water supply pressure Maximum Load Spin Speed Width Height Depth (inclunding the porthole) Information on the electrical connection is given on the rating plate on the inner edge of the appliance door Minimum Maximum Cotton...
Installation instruction Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bottom.
Water inlet An inlet hose is supplied and can been found inside the machine drum. Do not use the hose from your previous machine to connect to the water supply. 1. Open the porthole and extract the inlet hose. 2. Connect the hose with the angled connection to the machine.
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18mm. If your drain hose looks like this (see below) you do not require the «U»...
If you require any further advice please contact your local water authority. Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should this safety measure not be observed.
Environmental concerns Packaging materials The materials marked with the symbol recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Old machine Use authorised disposal sites for your old appliance. Help to keep your country tidy! The symbol on the product or on its packaging indicates that this product may not...
Standard guarantee conditions We, Zanussi-Electrolux, undertake that if within12 months of the date of the purchase this Zanussi-Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same...
For Customer Service in The Republic of Ireland please contact us at the address below: Electrolux Group (Irl) Ltd Long Mile Road, Dublin 12, Republic of Ireland Tel: + 353 (0)1 4090751 Email: firstname.lastname@example.org European guarantee This appliance is guaranteed by Electrolux, in each of the countries listed in the following page, for the period specified in the appliance guarantee or otherwise by law.
Addington Way, Luton, Bedfordshire LU4 9QQ 4, Limnou Str., 54627 Thessaloniki Slavonska avenija 3, 10000 Zagreb Longmile Road Dublin 12 C.so Lino Zanussi, 26 - 33080 Porcia (PN) Kr. Barona iela 130/2, LV-1012, Riga Verkiu,2 9, 09108 Vilnius, Lithuania Rue de Bitbourg, 7, L-1273 Hamm H-1142 Budapest XIV, Erzsébet királyné...
132973860 Subject to change without notice...