Related Manuals for Zanussi ZWG 6100P
Summary of Contents for Zanussi ZWG 6100P
- Page 1 User manual Washing Machine ZWG 680P ZWG 6100P Downloaded From WashingMachine-Manual.com Manuals...
-
Page 2: Table Of Contents
• It is dangerous to alter the specifications or en when moving it. attempt to modify this product in any way. • All packing and transit bolts must be re- moved before use. Serious damage can oc- www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals... - Page 3 • This appliance is designed for domestic use. polystyrene) can be dangerous to children - It must not be used for purposes other than danger of suffocation! Keep them out of chil- dren’s reach. those for which it was designed. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
-
Page 4: Frost Precaution
For more detailed point for the recycling of electrical and information about recycling of this product, electronic equipment. By ensuring this product please contact your local council, your www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals... -
Page 5: Product Description
Product description Detergent dispenser drawer Water drain hose Worktop Drain hose support Control panel Hose holders Door opening handle Water inlet hose Rating plate (on the inner edge) Mains cable Front adjustable feet Back feet www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals... -
Page 6: Technical Data
Maximum 0,8 MPa Maximum Load Cotton 6 kg Spin Speed Maximum 800 rpm (ZWG 680P) 1000 rpm (ZWG 6100P) Installation Unpacking • Remove the exter- nal film. Use a cut- Warning! ter, if necessary. • Read carefully the "Safety information"... - Page 7 • Remove the power supply cable and the draining and inlet hose from the hose hold- ers on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 8 Repeat the levelling action, if the appliance is with the appliance . not level and stable. The end of the drain hose can be positioned in four ways: • Hooked over the edge of a sink using the plastic hose guide. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 9 4 metres. An additional drain hose If the outlet spigot has not been used before, and joining piece is available from your Local remove any blanking plug that may be in Centre. place. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
-
Page 10: First Use
Daily use Sort out the laundry structions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. Follow the wash code symbols on each gar- ment label and the manufacturer’s washing in- www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals... - Page 11 Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). 1) do not use acetone on artificial silk. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 12 • large amounts of foam form during washing. Degrees of water hardness Water hardness is classified in so-called “de- grees” of hardness. Information on hardness of the water in your area can be obtained from the www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 13 • Rotate the flap propriate compart- downwards. ments of the dispens- • Carefully put the er drawer just before drawer back. starting the wash pro- gramme. Close the detergent dispenser drawer www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 14 . Select the new programme by turning the selec- tor to the desired programme. Start the new programme by pressing the button 6 again. The water in the tub will be not emptied out. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 15 Press simultaneously the buttons 3 and 4 for some seconds: the pilot light 7.2 comes on. This function stays permanently on. To remove it press the same buttons again until the pilot light 7.2 goes off. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 16 If you need to open the door, you must set the appliance to PAUSE (by pressing the button 6) and then wait a few minutes. After you have closed the door, press the button 6 again. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 17 Remove the laundry from the drum and carefully Follow the below instructions to empty out the check that the drum is empty. If you do not in- water: tend to carry out another wash, close the water www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
-
Page 18: Washing Programmes
RINSE HOLD, Prewash - Main wash - Rinses - Maximum spin speed at: 800 DELAY START, rpm for model ZWG 680P; 1000 rpm for model ZWG 6100P SUPER QUICK Max. load 6 kg - Reduced load 3 kg EXTRA RINSE White, coloured cotton and linen. - Page 19 Cold AUTOMATIC SPIN RE- Main wash - Rinses - Maximum spin speed at: 800 rpm for DUCTION, model ZWG 680P; 1000 rpm for model ZWG 6100P RINSE HOLD, Max. load 3 kg DELAY START, Highly energy efficient cold wash programme for lightly soiled EXTRA RINSE laundry.
-
Page 20: Consumption Values
60°- Cold AUTOMATIC SPIN RE- Main wash - Rinses - Maximum spin speed at: 800 rpm for DUCTION, model ZWG 680P; 1000 rpm for model ZWG 6100P RINSE HOLD, Max. load 3 kg DELAY START Trousers, shirts or jackets in denim and jersey realized with hi- tech materials. -
Page 21: Care And Cleaning
To run a maintenance wash: • The drum should be empty of laundry. • Remove the drawer. • Select the hottest cotton wash programme. • Use a normal measure of detergent, must be a powder with biological properties. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals... - Page 22 To clean the filter, proceed as follows: again. • turn programme selector dial to position • open the filter cov- er and insert the fil- • unplug the appliance; ter again; • open the door; www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
-
Page 23: What To Do If
Before contacting your local Service Centre, gineer. please carry out the checks listed below. Fault code and mal- Possible cause / Solution function www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals... - Page 24 • carry out the drain filter cleaning as described in "Cleaning the drain filter"; • at the end of cleaning action, close the door and insert the mains plug again; • run a drain programme to check if the appliance works now. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 25 • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one. www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 26 We recom- appliance and press the button 6 to restart the mend that you write the data here: programme. If the malfunction shows again, contact your Service Centre. The necessary data for the www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 27 Model description (MOD.) ........Product number (PNC) ..........Serial number (S.N.) ..........Mod..Prod. No..Ser. No..www.zanussi.com Downloaded From WashingMachine-Manual.com Manuals...
- Page 28 Downloaded From WashingMachine-Manual.com Manuals...