Potterton Gold H Range Installation & Service Instructions Manual page 36

Fig. 31
Cable Clamp
4-way Terminal Block
S/L
Fig. 33
36
© Baxi Heating UK Ltd 2012
Optional Pump Feed Connection
N
P/F
only required for fully TRV'd system
10.0 Installation
10.8 Making The Electrical Connections
WARNING: This appliance must be earthed
1. The electrical connections are on the right hand side of
the unit.
2. Undo the two screws securing the cable clamp and place
to one side (Fig. 31).
3. Route the incoming electrical cable/s through the
grommet in the support bracket. This will prevent damage
to the cable.
4. Lay the cable through the cable clamp to gauge the length
of cable required when it is connected to the 4-way
terminal block.
5. Connect the (S/L), (N) and (
4-way terminal block (Fig. 33) and refit the cable clamp
(Fig. 31).
6. Check the electrical installation for:-
earth continuity, short circuits, resistance to earth, correct
polarity and fuse failure.
) wires to the