AMT Datasouth Accel-7350 Service Manual page 65

(2) FC Home Sensor B Assembly Replacement
FC Home Sensor B Assembly consists of one FC home, and one OP home sensor located on base
plate R assembly.
REMOVAL
Step 1. Remove the top enclosure.
Step 2. Remove 2 pan head screws (S-17) from the mechanism stoppers left and right corners
of the mechanism. Rotate the mechanism up.
Step 3. Disconnect the harnesses of FC home sensor and OP home sensor on the control PCB.
Step 4. Remove the OP home sensor, 2 pan head screws (S-1) and cutting the tie wrap.
Step 5. Remove tie plate, 4 screws.
Step 6. Remove the FC home sensor 2 pan head screws (S-4) from the FC home
INSTALLATION
Follow the reverse of the above procedure.
sensor.
64