Kenmore Dual Fuel Range Use & Care Manual page 10

Setting Surface Controls (cont'd)
Setting the Bridge Burner
The Bridge Burner should be used with rectangular shaped cookware. Cookware like the cast-
iron Griddle that is supplied with your cooktop is designed specifically for best results with the
Bridge Burner.
The Bridge Burner feature may be used to combine the cooking power of 2 or if needed 3 gas
surface Burners located along the left-hand side of the glass cooktop. The left rear and left center
Burners are controlled by the left rear surface Control Knob. In addition the left front Burner may
be added to the Bridge Burner with the left front gas Control Knob.
Operating only the Left Rear Burner
1. Place cooking utensil centered over the left-rear surface Burner Grate.
2. Push the left rear surface control knob in and turn counterclockwise out of the OFF
position (See Figure 2).
3. Release the knob and rotate to the LITE position. Note: All electronic surface ignitors
will spark at the same time. However, only the left rear Burner will ignite.
4. Visually check that the left-rear burner has lit. Adjust the flame size by turning the
control knob between the first HI and LO settings (See Figure 3). DO NOT cook with
the surface control knob in the LITE position (The electronic ignitor will continue to
spark if the knob is left in the LITE position).
Operating the Bridge Burner
1. Place cooking utensil centered over the left-rear surface Burner Grate.
2. Push the left rear surface control knob in and turn counterclockwise out of
the OFF position (See Figure 2).
3. Release the knob and rotate to the LITE position (See Figure 2 & 3). Note:
All electronic surface ignitors will spark at the same time. However, only
the selected surface Burner will lite.
4. Visually check that the left rear Burner has lit.
5. Continue to rotate the gas control knob counterclockwise past the first LO
setting to the arrow marked Multi. The left center burner will lite.
6. Visually check that both the left rear and left center Burners are lit. Adjust
the flame size by turning the control knob between the second HI and LO
settings (See Figure 3).
7. Add the left front Burner if needed. Once lit, visually adjust the flame size
of the left front Burner to match the flame size of the Bridge Burner. DO
NOT cook with any of the surface control knobs in the LITE position (The
electronic ignitor will continue to spark if the knob is left in the LITE
position).
Off Off
Figure 3
Bridge Burner (left rear + left
center) adjustment area
10
Left Front Left Rear
Off
Off
Figure 1
Lite Lite Hi Hi Lo Lo Hi Hi
Multi Multi
Figure 2
Off
Left Rear Burner
lite position
Left Rear
Burner
adjustment
area
Left Center Burner
lite position
Off
Lo Lo