Advertisement
DPSQ50
CONTROL PLATE
©
(1) STATUS LED'S
GREEN LED: This indicator tells you that the unit has power and is turned on
when lit. If this LED is on you know that you have correct polarity in your power
hook-ups.
YELLOW LED: This indicator tells you that the unit has shutdown due to
overheating. When the unit has cooled down to proper operating temperature this
LED will go out. You may then turn the unit back on. Make sure you're not
overdriving the unit and that it has plenty of airflow around it, to avoid the
overheating problem.
RED LED: This indicator tells you that the unit has shutdown due to excessive
current draw. This will occur if you have too low of speaker impedance, a shorted
speaker, or a shorted speaker wire. When you have corrected the problem
simply turn the unit off and then back on to clear this indicator.
(2) CHANNEL SET B CONTROLS
MODE SWITCH: This switch selects the crossover mode for Channel Set B left
and right channels.
FREQUENCY ADJUST CONTROL: This control is used to set the range of the
selected crossover mode frequency.
INPUT LEVEL CONTROL: This control is used to set the input sensitivity of
Channel Set B. Use this control to match the voltage output of your source unit to
the DPSQ50
inputs. In minimum position (fully counter-clockwise) the
©
DPSQ50
will except an input of 5 volts RMS. In maximum position (fully
©
clockwise) the DPSQ50
will except an input of 150 mVolts RMS.
©
RCA (phono) INPUT JACKS: This is where you connect your source unit to
Channel Set B.
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
2
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
