Advertisement
(3) CHANNEL SET A CONTROLS
MODE SWITCHES: These switches select the crossover mode for Channel Set
A left and right channels.
BANDPASS ADJUST CONTROLS: These controls are used to set the range of
the selected crossover mode frequency.
INPUT LEVEL CONTOL: This control is used to set the input sensitivity of
Channel Set A. This control is used exactly as described above in the Channel
Set B section.
RCA (phono) INPUT JACKS: This is where you connect your source unit to
Channel Set A.
DPSQ50
CONNECTOR PLATE
©
(1) LINE OUT AND CONTROL
RCA (phono) LINE OUT JACKS: These jacks allow you to connect this unit to
another amplifier. This output is a line level connection.
MODE SWITCH: This switch selects the crossover frequency of the line out RCA
jacks. The cutoff frequency of the line out is adjusted by the High-pass
Adjustment of Channel Set A. This adjustment works only in high-pass and low-
pass modes.
(2) SPEAKER OUTPUTS
OUTPUTS: These 5 way binding posts are for connecting to your speakers. Be
sure that if you connect this unit in bridged mono operation, that your impedance
is not lower than 4 ohms or else you will damage the unit and void your warranty.
(3) POWER BLOCK
POWER BLOCK: This terminal is where you connect your Power, Ground, and
remote turn-on wires to this unit.
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
3
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
