Advertisement
READY, SET, PHASE!
Using your ToneBug Phaser
Insert a 9V alkaline battery or connect to a T-Rex Fuel Tank power
supply (not included).
Plug your guitar into the INPUT jack, and run a lead from the OUT-
PUT jack into your amp.
Use the RATE knob to set the speed of your modulation, and the
DEPTH knob to choose how "heavy" you want the effect to be.
Try switching between Modern and Vintage modes to get the tone
you're looking for, and then set your overall output volume with the
LEVEL knob.
TECHNICAL SPECIFICATIONS:
Input Impedance @ 1KHz
Output Impedance @ 1KHz
Power supply
Minimum Power supply Voltage
Maximum Power supply Voltage
Current Draw @ 9V DC
Maximum input signal Vp/p
Battery Type
Battery Life
External connectors
Controls
Depth
Width
Height
Weight (excl. battery)
Higher than 1 M Ohm
Lower than 1 K Ohm
9V DC
8V DC
12,5V DC
75 mA
2,5 Vp/p
9V battery 6F22 Alkaline
0,5 to 1 Hours
Input Jack. Output Jack, 9V DC Jack (center
pin negative)
On/Off, Rate, Modern, Vintage, Depth
120 mm
78 mm
60 mm
0,404 Kg
Advertisement
Need help?
Do you have a question about the ToneBug and is the answer not in the manual?
Questions and answers