GE GTRS0 Series Technical Service Manual page 21

Freezer Door
1. Tape freezer door shut with masking tape.
Remove the hinge cover from the freezer
door hinge (some models).
2. Remove 2 (T-20) Torx head screws and the
top hinge.
3. Remove the tape and tilt the door away from
the cabinet. Lift the door off the center hinge
pin and place on a protected surface.
Fresh Food Door
1. Tape the fresh food door shut with masking
tape.
2. Remove the center hinge pin with a 3/4-in.
socket.
3. Remove the tape and tilt the door away from
the cabinet. Lift the door straight up and off
the bottom hinge and place on a protected
surface.
Note: If the washer is not on the bottom hinge,
check to see if it is stuck to the bottom of the
door.
Reversing the Doors
1. Install the top hinge and screws on the
opposite side of the cabinet. Do not tighten
the screws at this time.
2. Remove the base grille by pulling it straight
out from the unit.
Note : If the washer is not on the bottom hinge,
check to see if it is stuck to the bottom of the
door.
3. Using a Torx driver, remove the screws and
bottom hinge from the cabinet and install on
the opposite side of the cabinet.
Top Hinge
Hinge Pin
– 7 –