Care And Cleaning; Defrosting; Cleaning The Inside - Electrolux EFC152NPAW Instruction Manual

31 electrolux how to use
Warning high temperature
1- When the temperature is not normal, the display will illuminate with
letters.
2- The alert sound will turn off when button
seconds.
Memory
When the freezer is turn on, the temperature adjustments are the same as the
last time that the freezer was turn off.
Compressor protection
The compressor always works for 5 hours, and then stops for 5 minutes as a
protection system.
Sensor fail
When the sensor temperature is not correct, the temperature indicator will
show code E1. When this happens, the compressor will work in a cycle of 1
hour working and then 1 hour stop.
is press for more than 3

Care and cleaning

Between defrosts
In order to avoid defrosting your
freezer often, use a plastic scraper to
remove the ice build-up. Scrap the ice
upward. Never use any metal
instrument to remove the frost as it
may damage the cooling coils and will
void the warranty.

Defrosting

Defrost and clean your freezer when
the ice layer inside of it is between 5
and 10 mm-thick. The frost can
accumulate faster at the top of the
freezer due to the warm and damp air
that enters the freezer when the lid is
open. Remove the food and let the lid
open while defrosting the freezer.
The defrost water will drain out. Check
the pan occasionally so the water
does not overflow. Replace the outer
drain plug and the interior freezer
cover when the defrost is completed.
1. Remove the frozen food from the
freezer and place it in a cooler to
protect it.
2. Unplug the freezer. The power
supply light should be off.
3. During the defrost process, the ice
melts into the cabinet.
4. Remove the drain plug on the
inside floor of the freezer by pulling
it straight out.
5. Place a shallow pan outside the
drain outlet.
care and cleaning electrolux 32
6. Make sure that the pan does not
overflow.
7. Replace the plug on the inside
floor.
8. Allow the appliance to cool down
for at least 2 hours.
9. Return the food to the freezer.
Do not use boiling water because it
may damage the plastic parts.
However, warm water can help to melt
the ice faster.

Cleaning the inside

After defrosting the freezer, wash the
freezer inner surfaces with a solution
of two tablespoons of baking soda in
one quart (1.136 liters) of warm water.
Rinse and dry. Wring excess water out
of the sponge or cloth when cleaning
in the area of controls, or any
electrical parts.
Wash the removable parts using the
baking soda solution mentioned
above, or mild detergent and warm
water.
Rinse and dry. Wash the door seal
using mild detergent, rinse with clean
water and dry it. Never use metallic
scouring pads, brushes, abrasive
cleaners, or alkaline solutions on any
surface. Do not wash removable parts
in a dishwasher.