Special Functions; Oven Sensor And Sensor Circuits - GE ZEK957 Series Technical Service Manual

Special Functions

The control has a section that can be entered to
change how the control will work. To enter this
section, press and hold BAKE and BROIL pads
for 2 seconds. S F appears in the display. Select
the area to change. When the change has been
made, press START to return to Time of Day.
• End-of-Cycle Tone - Press TIMER pad.
*Display shows Con Beep when control is set
for Continuous End-of-Cycle Tone or Beep
when set for Noncontinuous.
• °F or °C - Press Broil pad. *Display will show
either F or C. Press Broil pad again to
change.
• 12 hour, 24 hour, or blank out Time of Day
Clock - Press Clock pad. *Display will show
12 hr, 24 hr, OFF for blank clock. Press again
to change.
• Cook & Hold (used only with Time Bake or
Delay Bake functions) - Press Cooking Time
pad. *Display will show either Hld On or Hld
Off. Press again to change.
• Child Lockout - Press CLEAN. *Display will
show Loc On (when any heating functions are
tried, display will show Off). Press CLEAN
again for Loc Off, control unlocked.
• 12-hour shutdown comes set to shut down
after 12 hours of continuous operations; this
can be eliminated - Press Delay Start pad.
*Display will show No Shdn. To turn back on,
press Delay Start pad again and display will
show 12 Shdn.
Note: Sabbath is between No Shdn and 12 Shdn.
• Sales Mode (special feature added for sales
floor demonstration) - Press Clock a n d Timer
pads at the same time. *Display will start to
cycle through the different modes of operation.
• Sabbath Mode (GE models only) disables all
but bake, timebake, no beeps, and 12h shut-
down override, and puts symbols on red
display during bake. Access by pressing Delay
Start pad until display shows Sabbath. Exit by
pressing Delay Start pad until No Shdn o r 12
Shdn shows.

Oven Sensor and Sensor Circuits

The control monitors the oven temperature
through the oven temperature sensor. The sensor
on these models is located on the upper left corner
of the rear oven wall. To access, remove 2 screws
and pull the wire and the connector through the
oven back.
– 23 –