Clarion DXZS1SUSB Owner's Manual page 17

Basic Operations
• Adjusting the treble
The treble gain and treble FREQ (center
frequency) can be adjusted as follows.
The adjustment can only be performed when
the OZE is set to "OZE OFF".
2-1. Select "TREBLE".
2-2. Press the
[~II
ENT] button.
2-3. Push the [SEEK PANEL] leftward or
rightward and select from:
"T GAIN"
+-+
"T FREQ"
3·1. Press the [UP] or [ON] button to adjust the
gain and FREQ (center frequency).
T GAIN: -6 to +6 (The factory default
setting is "0")
T
FREQ: 8KHz/12KHz (The factory default
setting is "12K")
3-2. Press the
[~II
ENT] button to return to the
previous mode.
• Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select
"5
RESTOR".
3-1. Press the [UP] or [ON] button to adjust.
Each time you press the [UP] or [ON]
button, the sound restorer changes in the
following order:
"OFF" +--~
"1"
+-+
"2"
{--*
"3"
*
The factory default setting is
"OFF".
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1:
For music sources compressed for high
quality at low bit rate
2:
For music sources compressed for
standard quality at low bit rate
3:
For music sources compressed for low
quality at low bit rate
• Setting high pass filter
2-1. Select "HPF".
3-1. Press the [UP] or [ON] button to select the
setting. Each time you press the [UP] or
[ON] button, the setting changes in the
following order:
"THROUGH"
+-+
"50Hz"
+-+
"80Hz"
+-+
"120Hz"
*
The factory default setting is "THROUGH"
(through).
• Setting low pass filter
I
2-1. Select "S-W LPF". •
3-1. Press the [UP] or [ON] button to select the
setting.
Each time you press the [UP] or [ON]
button, the setting changes in the following
order:
"THROUGH"
{-l"
"50Hz" {... ~ "80Hz"
{-+
"120Hz"
*
The factory default setting is 'THROUGH"
(through).
• Adjusting the balance
2-1. Select "BALANCE".
3-1. Press the [UP] button to emphasize the
sound from the right speaker, press the
[ON] button to emphasize the sound from
the left speaker.
*
The factory default setting
is "CENTER".
(Adjustment range: L 12 to R12)
• Adjusting the fader
2-1. Select "FADER".
3-1. Press the [UP] button to emphasize the
sound from the front speaker, press the
[ON] button to emphasize the sound from
the rear speaker.
*
The factory default setting is
"CENTER".
(Adjustment range: R12 to F12)
DXZ575USB
13