Powering Receiver With Esc; Failsafe; Troubleshooting - Spektrum SR200 Instruction Manual

EN
Powering the receiver with an ESC
Battery
Receiver
2.4Ghz DSM
SR200
THR
SPORT SURFACE
RECEIVER
STR
BIND
3. With the steering wheel, throttle trigger and Aux channel (if applicable) in the desired preset
failsafe positions (generally full brake and neutral steering), initiate the bind process with your
Spektrum transmitter. This stores the failsafe positions. Continue to hold the failsafe positions
until the binding process is complete. Please see the next section for more information
about failsafe.
4. The LED on the receiver should now be solid, indicating a successful bind has taken place.
5. Once the bind process is complete and before power is cycled on the receiver, remove the
bind plug and store it in a convenient place. Failure to remove the bind plug will result in the
receiver going back into bind mode.
The only time it is necessary to do a rebind is if different failsafe positions are desired e.g.,
servo travel has been reversed after the initial bind, or if the receiver is to be bound to a
different model memory.

Failsafe

Failsafe positions are set during binding. In the unlikely event that the radio link is lost during use,
the receiver will drive the servos to their preprogrammed failsafe positions (normally full brakes
and straight steering). If the receiver is turned on prior to turning on the transmitter, the receiver
will enter failsafe mode, driving the servos to their preset failsafe positions. When the transmitter
is turned on, normal control is resumed.
2.4GHz Troubleshooting Guide
Problem
The system will not
connect
Electronic
Speed Control
Steering Servo
Possible Cause
Your transmitter and receiver
are too close together
You are around metal
objects
The model selected is not
the model bound to
Your transmitter was
accidentally put into bind
mode and is no longer
bound to your receiver
To Motor
Solution
Move transmitter 8 to 12 feet
from receiver
Move to an area with less metal
Check model selected and en-
sure you are bound to
that model
Rebind your transmitter
and receiver