Table of Contents
Advertisement
Parallel Port
KB
Mouse
The 25-pin connector at location J1 is for connecting an external
parallel port. The parallel port connects your PC to a parallel printer.
It supports SPP, ECP and EPP.
Setting
SPP
(Standard Parallel Port)
ECP
(Extended Capabilities Port)
EPP
(Enhanced Parallel Port)
Connecting the Parallel Port Cable
Your parallel port may be mounted on a card-edge bracket. Install
the card-edge bracket to an available slot at the rear of the system
chassis then insert the cable connector to the J1. Make sure the
colored stripe on the ribbon cable is aligned with pin 1 of J1.
Hardware Installation
2
1
Function
Allows normal speed operation but
in one direction only.
Allows parallel port to operate in
bidirectional mode and at a speed
faster than the SPP's data transfer
rate.
Allows bidirectional parallel port op-
eration at maximum speed.
2
2 5
41
Advertisement
Table of Contents
